###
DOI:
工程科学与技术:2011,43(6):238-242
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
砂带恒压磨削的有限元热学模型及实验验证
(1.重庆大学 软件学院;2.重庆大学 机械工程学院)
Finite Element Thermal Model and Experimental Verification for Constant Pressure Belt Grinding Process
(1.School of Software Eng.,Chongqing Univ.;2.College of Mechanical Eng.,Chongqing Univ.)
摘要
图/表
参考文献
相似文献
本文已被:浏览 1479次   下载 1
投稿时间:2011-02-24    修订日期:2011-04-24
中文摘要: 为了研究恒压砂带磨削的磨削温度与磨削参数之间的关系,改善磨削加工工艺,提高磨削质量,从磨削接触区域的弹性接触分析入手,研究了恒压砂带磨削区域上热源分布规律,建立了恒压砂带磨削的有限元热学模型,分析了磨削过程中的热现象,并进行了磨削温度的实验验证。结果表明,磨削热大部分集中于中间较宽的接触区域,单点磨削温度前期升温速度较快,而后期阶段降温速度则较为缓慢,磨削区面积较大时,磨削热分布较为平均。恒压砂带磨削实验采用热电偶露头埋设和浅埋设2种测温方式,分别测量了磨削区表面磨削温度和表层磨削温度,实验结果和模拟结果基本吻合,因此,所建立的恒压砂带磨削的有限元热学模型是有效的。
Abstract:In order to study the relationships between the grinding temperature and grinding parameters for constant pressure grinding process, a finite element thermal model was derived and expressed. So the grinding process and quality was improved. Based on the elastic contact analysis in the grinding contact area, the heat distribution of the grinding contact area was studied for the constant pressure belt grinding process.A finite element thermal model was implemented.Thermal phenomena were analyzed in the constant pressure belt grinding process.The experiments of grinding temperature were completed. The results showed that most of grinding heat concentrates in the middle of a wide contact area. Grinding temperature rises faster in the heating stage, and drops slow in the cooling stage. When the grinding area is large, the grinding heat distribution is more average. Experiments of the constant pressure grinding process used two temperature measurement methods of buried outcrop and shallow buried. The grinding temperature was measured on the surface and under the surface in grinding area. Experiment results and simulation results were probably consistent.
文章编号:201100151     中图分类号:    文献标志码:
基金项目:重庆市科技攻关计划资助项目(2008AB3014)
作者简介:
引用文本:
张毅,张伟文,郭钢.砂带恒压磨削的有限元热学模型及实验验证[J].工程科学与技术,2011,43(6):238-242.
Zhang Yi,Zhang Weiwen,Guo Gang.Finite Element Thermal Model and Experimental Verification for Constant Pressure Belt Grinding Process[J].Advanced Engineering Sciences,2011,43(6):238-242.